Katana Owners Club U.K.

Any thoughts on supplier or quality ? pattern ok ? or Suzuki ?

Thanks awfully

Pete

Could do worse than speak to deeds

Cheers FBJ, looking at the lower bearing, do i need a special tool to get this on ? or does it need a bearing press do do it ?

Cheers

Pete

I use a a 3/8 extension bar I have molded

And a decent size hammer

I like hammers me......

Katgeezer wrote:And a decent size hammer

I like hammers me......

Yeah, and my favourite hint again: hammer it hope like a man, ha ha.

Cheers Mick. will go Suzuki then.

Ta

Pete

I used these, good quality and a lot cheaper than Suzuki

http://www.bikebearings.co.uk/" onclick="window.open(this.href);return false;

I use pyramid bearings from Scotland..............Suzuki OEM price would be very expensive!

http://www.pyramidparts.co.uk/" onclick="window.open(this.href);return false;

I also use a brass drift to knock mine in............but if youre real carefull you can use any drift with a flat face!

Can you just use someone with a flat face???