Katana Owners Club U.K.

Hi All,

I'm more or less ready to split the casings, and while i'm at it it would be false economy to not change the oil seals.

I have dimensions for the gearchange rod seal (12x22x9), but I'm looking for the size of the crankshaft seal (ignition pickup end). I have Suzuki part number 0928330031, superseded by 0928330048.

I can get them from the local bearing supplier at a fraction of the cost that I would pay Suzuki for them (and they would probably be the same make).

Can't seem to see the dimensions stamped on it....

Cheers,

J

id go for gen suzuki if it were mine. only because its a lot of faff to discover later that the aftermarket one isnt quite upto the job, is it worth saving a tenner on a seal then having to drop and strip the engine again?

Can't help you with the sizes but there is one on Ebay a the mo.

09283-30048 on Ebay
http://www.ebay.co.uk/itm/NOS-Genuine-G ... 1101498910
£12.90 with the postage

Gear change one is part 09285-12006 I think:
http://www.ebay.co.uk/sch/i.html?_from= ... _PrefLoc=1
Postage all to high on those, but the Suzuki price is only £5.63 so that is what your local Suzuki place can do it for as well - no postage to pay and cheap enough.

Rob

Thanks for that....

Duly ordered!

Cheers,

J