Re: XN85 - Bad vibration at around 3000rpm
Posted: Sun Oct 16, 2011 8:32 pm
Did u powder coat the engine mounts? Re tighten ur mounts
Katana Owners Club U.K.
For owners of the Suzuki Katana as designed by (or inspired by) Target Design
https://www.katanaownersuk.club/forum/
XN85 - Bad vibration at around 3000rpm
https://www.katanaownersuk.club/forum/viewtopic.php?f=7&t=1345
Page 1 of 1
Re: XN85 - Bad vibration at around 3000rpm
Posted: Sun Oct 16, 2011 9:00 pm
You need to remove the mounts and cut the coating of where the mating faces meet
Re: XN85 - Bad vibration at around 3000rpm
Posted: Mon Oct 17, 2011 7:04 am
What did you do enginewise during the rebuild?
Re: XN85 - Bad vibration at around 3000rpm
Posted: Mon Oct 17, 2011 9:23 am
I can only change a spark plug 
Pete
Pete
Re: XN85 - Bad vibration at around 3000rpm
Posted: Mon Oct 17, 2011 9:48 am
I bet you're able to do four of'em, cally.callyboy wrote:I can only change a spark plug
Pete
Tim,
as you say everything's got balanced, I take it you matched the pistons for same wheight, too?
In case you don't have any suspects enginewise, do you have proper bar end weights? Not the hip alloy or even carbon ones, but solid steel? They might help a bit then.
Re: XN85 - Bad vibration at around 3000rpm
Posted: Mon Oct 17, 2011 4:00 pm
cam chain could be 1 tooth out ?
Re: XN85 - Bad vibration at around 3000rpm
Posted: Thu Oct 20, 2011 6:00 pm
Best ignore that boost guage, stick a "t" piece in line and run a 1 bar guage to check what the actual boost is. is the waste gate stuck open ? Mine was stuck shut at mold this year and made the boost keep building until the ignition cuts @12psi.
As for your vibration. . . . .not got a clue as mines smooth all the way through the rev range,
As for your vibration. . . . .not got a clue as mines smooth all the way through the rev range,