1100 valve clearances

From a simple dustcap to a full on turbo-nitrous breathing monster.
If you have any questions, here's the place to ask.
Post Reply
User avatar
Kryten
Club Member
Posts: 1828
Joined: Sun Dec 26, 2010 11:13 pm
Location: North Norfolk
Has thanked: 128 times
Been thanked: 269 times

Re: 1100 valve clearances

Post by Kryten » Mon Jun 24, 2019 3:15 pm

0.008 mm is what I set mine to. But then it is a "Boat Anchor"
Jim

750 SZ (Not So) Skruffy Kat
1000 SZ Nearly there!
7/11 SZ Back of the shed
T509 SpeedTrip

It was a New Day yesterday but, by God, it's an Old Day now!
Top
stockcar
Club Member
Posts: 514
Joined: Fri Dec 31, 2010 1:53 pm
Has thanked: 7 times
Been thanked: 63 times

Re: 1100 valve clearances

Post by stockcar » Mon Jun 24, 2019 3:48 pm

yes confirmed in the Suzuki 'bible' as 0.07mm - 0.12mm
Top
User avatar
Kryten
Club Member
Posts: 1828
Joined: Sun Dec 26, 2010 11:13 pm
Location: North Norfolk
Has thanked: 128 times
Been thanked: 269 times

Re: 1100 valve clearances

Post by Kryten » Mon Jun 24, 2019 7:24 pm

Blix wrote:
Kryten wrote:0.008 mm is what I set mine to. But then it is a "Boat Anchor"
That’s very small :shock:
Very true, but I may have had finger trouble caused by a cold beer in the Mediterranean sunshine. Should of course been 0.08mm :D
Jim

750 SZ (Not So) Skruffy Kat
1000 SZ Nearly there!
7/11 SZ Back of the shed
T509 SpeedTrip

It was a New Day yesterday but, by God, it's an Old Day now!
Top
Post Reply

Return to “Technical Q&A”